This is an old revision of the document!
Dragonfruit Team Meeting - Week of February 5th, 2018
Attended: Kyaw, Tyler
Updates 2/5
- Suggested Edits from Kyle review on Dragon Fruit PCB V4
- General:
- reallocate bottom plane to use as various split power planes
- a ground plane is not needed on both top and bottom. instead, you can use vias to connect grounds from the bottom as needed
- change placement of all headers to be on the edge of the board (good practice)
- this helps to avoid cutting into power and ground planes
- don't route traces into component pads diagonally (try to hit the pad straight)
- avoid sudden trace width reduction (xb_en, n46 signal)
- due to the pin pitch of the voltage regulator, the plane is narrowed significantly
- if the effective trace width of a plane is equivalent to that of a regular trace, it defeats the purpose of using a plane
- rearrange components to maximize effective trace width from planes but also keeping planes compact
- keep proper clearances from holes (C16 and U6)
- avoid creating additional planes on the top layer
- the +5V_SEN_S plane on the top severs the ground plane
- +5V_SEN_S is already being used as the bottom plane so you can just use vias to connect components to that power plane
- top plane should be reserved exclusively for gnd
- remove gnd nubs (C27)
- avoid using traces if planes can be utilized to connect signals
- don't need to use traces to route gnd signal for gps
- use vias instead
Future Tasks
SCEL Meeting 2/3/18!!!- Generate Gerber files once green light is LIT from Kyle.