1. Use the Arduino IDE to program the device using the AVRISP MkII Programmer.
2. Use an ISP connector to attach the programmer to the DragonFruit board.
3. Connections: MISO (1), VCC(2), SCK(3), MOSI(4), RESET(5), and GND(6).
4. Make sure that you have the right board selected: Arduino Uno w/ Atmega328.

Note: Board must be powered using an external voltage source (e.g. battery or generator).

1. Creating Schematics
2. Creating Board
3. Generating GBR files

Tips on how to design a professional PCB can be found here.

Steps on how to send your design to a professional manufacturer can be found here.

Contributing authors:

Created by garrettz on 2016/02/24 21:08.