Attended: Keane, Dylan, Tyler and Garrett

• Housing 3D printing complete
  • modifications need to be done
• Final PCB design complete
  • Sent files to Tyron
  • Waiting to mill
• Code complete (pending testing)
  • Battery Voltage needs to be tested
  • wrote code to process panel voltage (Need to be tested
• Solar irradiance pins known

• XBee able to communicate one way but not both (Resolved within the week)
  • Ripped up breadboard to redo
  • Problem fixed with help of Jaimie
  • Xbee was not being powered
• Last minute changes to PCB
  • Voltage divider connected to Atmega and Solar Panel diode to read panel voltage
  • Add DCIN component to Schematic and then to PCB
• Last minute changes to housing
  • make port for solar panel cable to charging chip
  • account for battery

• Figure out whats wrong with XBee (Resolved)