Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ===== Week 3 ===== ==== Meeting Minutes January 31, 2019 ==== **Attended: Mizpah, Sharmaine, Xiao** === Updates === * Continue populating new PCB * Continue debugging 2nd PCB: conclusion: solar chip is not soldered on properly - since LEDs are not connected to ground - solution: resolder solar chip ===To Do=== * resolder solar chip on the second board * Finish up populating new board ==== Meeting Minutes February 1, 2019 ==== **Attended: Mizpah, Sharmaine, Xiao** === Updates === * Resoldered solar chip * Debug solar chip * resoldered but same problems as before * tried running on the 3rd board. same problems as before * leaking voltage? * Kenneth mentioned that their board before had problems with the switch as the switch was leaking voltage into the board. * we removed the switch and soldered on wires in its place on TX and RX ===To Do=== * Continue Debugging solar chip. * Work with Firmware team to debug. weatherbox/bumblebee/week_3_-_january_28_2019.txt Last modified: 2021/09/19 21:59(external edit)