Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_7_-_october_16_2019 [2019/09/09 18:58] ryoung created |
weatherbox:bumblebee:week_7_-_october_16_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| === Updates === | === Updates === | ||
| - | * | + | * rescheduled hours to Monday October 14. |
| + | * Looked at how to correctly connect the pins to the board, names of the pins are different | ||
| + | * Had to look at the description of each pin on the Boost to match the board description | ||
| + | * got some pins incorrect, and our board started smoking again | ||
| ===To Do=== | ===To Do=== | ||
| * Debug PCB from last semester | * Debug PCB from last semester | ||
| + | * connect the pins from Boost converter to PCB correctly | ||
| + | * work on progress report | ||
| ==== Meeting Minutes October 18, 2019 ==== | ==== Meeting Minutes October 18, 2019 ==== | ||
| Line 13: | Line 18: | ||
| === Updates === | === Updates === | ||
| - | * Configured XBee Pro S2C | + | * connect the pins from Boost converter to PCB correctly |
| - | - Asked Firmware team for help | + | * work on progress report |
| - | - In XCTU: | + | |
| - | - Since XCTU couldn't recognize new XBee's, we used Xbee recovery | + | |
| - | - Update firmware to Zigbee protocol | + | |
| - | - Configure 3 XBees: 2 routers and 1 coordinator | + | |
| - | * Continue populating the board | + | |
| ===To Do=== | ===To Do=== | ||
| * Continue debugging old PCB | * Continue debugging old PCB | ||