Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
weatherbox:bumblebee:how_to_range_test [2021/03/07 21:48]
lcorpuz
weatherbox:bumblebee:how_to_range_test [2021/09/19 21:59] (current)
Line 1: Line 1:
-===Using the XCTU Program:===+**=== Using the XCTU Program: ===**
   - Make sure everything is connected: wires, code is correct   - Make sure everything is connected: wires, code is correct
   - Make sure all Xbees recognize one another (close the plug(+)   - Make sure all Xbees recognize one another (close the plug(+)
Line 34: Line 34:
 LED on XBee should be on; not blinking? LED on XBee should be on; not blinking?
  
-=== Range Testing w/ PCBs ===+**=== Range Testing w/ PCBs ===**
   * Connect solar charging chip and relay xbee onto the PCB board (we used v4.0)   * Connect solar charging chip and relay xbee onto the PCB board (we used v4.0)
   * Connect battery into the solar charging chip (Batt)   * Connect battery into the solar charging chip (Batt)
Line 43: Line 43:
   * Make sure coordinator is found; Mac Address: 0013A20041287FF9   * Make sure coordinator is found; Mac Address: 0013A20041287FF9
 {{ :​weatherbox:​bumblebee:​screen_shot_2021-03-07_at_11.27.21_am.png?​400 |}} {{ :​weatherbox:​bumblebee:​screen_shot_2021-03-07_at_11.27.21_am.png?​400 |}}
-Click on select all device and then add select device +  * Click on select all device and then add select device 
-Looking at the "Radio Module"​ side, looking at coordinator,​ click on discover remote devices +  ​* ​Looking at the "Radio Module"​ side, looking at coordinator,​ click on discover remote devices 
-Make sure Relay Xbee is identified; select all and then click select devices +  ​* ​Make sure Relay Xbee is identified; select all and then click select devices 
-click on tools icon and select 'range testing'​ +{{ :​weatherbox:​bumblebee:​screen_shot_2021-03-07_at_11.34.21_am.png?​400 |}} 
-Click '​select local device":​ should say something like zigbee +  * Click on tools icon and select 'range testing'​ 
-Make remote selection says ...FFB (Relay xbee) +  ​* ​Click '​select local device":​ should say something like zigbee 
-Change number of packets to 15 +  ​* ​Make sure remote selection says ...FFB (Relay xbee) 
-Start Range Testing! +  ​* ​Change number of packets to 15 
 +  ​* ​Start Range Testing! 
 +{{ :​weatherbox:​bumblebee:​screen_shot_2021-03-07_at_11.36.11_am.png?​400 |}}
  
  
  • weatherbox/bumblebee/how_to_range_test.1615153701.txt.gz
  • Last modified: 2021/09/19 21:59
  • (external edit)