Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_12_-_april_8_2019 [2019/04/11 23:50] xchen created |
weatherbox:bumblebee:week_12_-_april_8_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Week 10 ===== | + | ===== Week 12 ===== |
| ==== Meeting Minutes April 11, 2019 ==== | ==== Meeting Minutes April 11, 2019 ==== | ||
| Line 7: | Line 7: | ||
| * Andrew mentioned that it's up to us whether or not we redesign our PCB | * Andrew mentioned that it's up to us whether or not we redesign our PCB | ||
| * We'll try to build our bare Arduino board and have it run at 5V and 16MHz to check if it works. | * We'll try to build our bare Arduino board and have it run at 5V and 16MHz to check if it works. | ||
| - | + | - Bare Arduino works with 5V, 16MHz | |
| + | * Finished modifying schematic and PCB --> Atmega runs on 5V, Xbee runs on 3.3V | ||
| + | - Ordered new PCB and 5V regulator | ||
| ===To Do=== | ===To Do=== | ||
| - | * | + | * Have to make Bare Arduino run on 3.3V with 8MHz while waiting for new PCB and voltage regulator to be delivered |
| Line 16: | Line 19: | ||
| === Updates === | === Updates === | ||
| - | * | + | * We ordered more XBees, capacitors, and clocks to use up our Ron Ho fund. |
| + | * We also ordered 3.3V 8MHz bootloaded atmegas. | ||
| ===To Do=== | ===To Do=== | ||
| * | * | ||