Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_1_-_january_14_2019 [2019/01/17 23:38] sjavier created |
weatherbox:bumblebee:week_1_-_january_14_2019 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| === Updates === | === Updates === | ||
| - | * | + | * Started working with XBee Pro S2C |
| + | - Couldn't configure because Xbee is in DigiMesh instead of ZigBee | ||
| + | * Continue populating another PCB board | ||
| ===To Do=== | ===To Do=== | ||
| - | * | + | * Debug PCB from last semester |
| ==== Meeting Minutes January 18, 2019 ==== | ==== Meeting Minutes January 18, 2019 ==== | ||
| Line 14: | Line 16: | ||
| === Updates === | === Updates === | ||
| - | * | + | * Configured XBee Pro S2C |
| + | - Asked Firmware team for help | ||
| + | - In XCTU: | ||
| + | - Since XCTU couldn't recognize new XBee's, we used Xbee recovery | ||
| + | - Update firmware to Zigbee protocol | ||
| + | - Configure 3 XBees: 2 routers and 1 coordinator | ||
| + | * Continue populating the board | ||
| ===To Do=== | ===To Do=== | ||
| - | * | + | * Continue debugging old PCB |