Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
weatherbox:bumblebee:week_1_-_september_6_2017 [2017/09/08 23:37] iaribal |
weatherbox:bumblebee:week_1_-_september_6_2017 [2021/09/19 21:59] (current) |
||
---|---|---|---|
Line 13: | Line 13: | ||
==== Meeting Minutes September 8,2017 ==== | ==== Meeting Minutes September 8,2017 ==== | ||
+ | **Attended:Isaiah, Kayla, Rebecca** | ||
+ | Actions: | ||
+ | *Replaced both capacitors (both to 10 μF) | ||
+ | *Changed resistor added last meeting from 1 kΩ to 10 kΩ to receive steady voltage of 3.33 V. | ||
+ | * Started from square one, and ran through a bunch of different test | ||
+ | * Tested by hooking up bare arduino to a power supply. Both 5V into the 3.3V reg and just 3.3V to the whole circuit | ||
+ | * Made sure xbees were configured correctly | ||
+ | * Sent simple test packets between the 3 xbees using XCTU | ||
+ | * Tested the relay using an arduino instead of our bare arduino | ||
+ | * After seeing the relay work using 2 arduinos, we went back to using one arduino to send and the bare arduino to relay | ||
+ | Current Concerns: | ||
+ | *Found that 1 and 3 cannot communicate with each other | ||
+ | *Encountered two defective arduino boards | ||
+ | *Must add additional LEDs for debugging | ||
+ | *Find solution to rid of hardcoding address | ||
+ | Outcomes: | ||
+ | * Relay is now working properly | ||
+ | * Not quite sure what fixed it | ||
+ | * Possible reasons: | ||
+ | * Xbee wasn't getting enough power | ||
+ | * Somewhere in the code got messed up | ||