Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_3_-_february_3_2020 [2020/02/04 03:34] ryoung |
weatherbox:bumblebee:week_3_-_february_3_2020 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| === Updates === | === Updates === | ||
| - | * none | + | |
| + | * Talked with Dr. Kuh | ||
| + | * Taught Arnold and Raellis a lot of bumblebee | ||
| + | * Configured Xbee S2C (coordinator, relay, send) | ||
| + | * 1 Uploaded Code to Atmega328P | ||
| + | * 2 Coordinator and Relay were not detecting Router Xbee; updated firmware and was able to detect | ||
| + | * 3 Coordinator is not receiving any packets | ||
| + | * 3a. Relay debug LED is not lighting up; no packets are being received or sent | ||
| + | * 3b. May need to recheck code that was uploaded | ||
| + | * 4. Compared working relay code and old relay code | ||
| + | * 4a. Found that the LED was not declared correctly; originally declared as int led=9 | ||
| + | * 4b. Changed it to #define led 9 (??????????) | ||
| ===To Do=== | ===To Do=== | ||
| - | * Continue debugging old PCB | + | * Continue debugging old PCB |
| + | * Range test Xbee S2C | ||
| + | * Find compatible 5V regulator | ||
| + | * Fabricate a new board that will incorporate Sparkfun 5V regulator | ||
| + | * Use thru holes (header) | ||
| + | * try to finish PCB design by next week Wednesday 2/12 | ||
| + | |||