Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_8_-_march_7_2017 [2017/03/07 23:34] iaribal |
weatherbox:bumblebee:week_8_-_march_7_2017 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| * No longer need to press reset button when uploading program to bare Arduino | * No longer need to press reset button when uploading program to bare Arduino | ||
| * Only able to upload once | * Only able to upload once | ||
| + | |||
| + | ====Meeting Minutes March 9, 2017==== | ||
| + | |||
| + | **attended: Isaiah, Kayla** | ||
| + | |||
| + | === Updates === | ||
| + | * Can now send frame from XCTU to Xbee on the bare Arduino | ||
| + | * Can now send frame from Xbee on bare Arduino to XCTU | ||
| + | * Our problem was that we forgot that the Xbee works with 3.3V. Added a 3.3 voltage regulator | ||
| + | * Started to test if the atmega can run on 3.3V | ||
| + | * Doesn't work if you still use the 16 MHz Clock | ||
| + | * Doesn't seem to work with a 8 MHz Clock | ||
| + | * Possible solution, re-burn the bootloader for 3.3V | ||
| + | |||
| + | |||