This is an old revision of the document!


Problems & Solutions - Quartz 2025

Problems:

  • Several of the connections in the Schematic Editor didn't have Netclasses
  • Footprints were missing for a few of the parts of the Diya PCB

Solutions:

  • Make sure to thoroughly check connections to ensure that they have Netclasses
  • For the parts that don't have Footprints, use similar ones with the same dimensions

Problems:

  • Blink program code was not uploading to Arduino, even after changing the breadboards, capacitors, microcontroller (three times), FTDI and as well as the entire setup

Solutions:

  • Change the components, since it could be due to a faulty one
  • Check setup, making sure that the connections and circuit is correct by following the tutorial
  • If still not working, restart from the beginning and try again
  • Cross reference BME280 tutorial schematic to Bare Bone Arduino schematic

Problems:

  • Similar problems to Kicad tutorials, missing Netclasses and Footprints

Solutions:

  • Double check everything thoroughly to make sure all connections have Netclasses and that the Netclasses are correct
  • For the components missing Footprints, replace with components with similar dimensions

Problems:

Solutions:

Problems:

Solutions:

Problems:

Solutions:

  • problems_solutions_-_quartz_2025.1744082325.txt.gz
  • Last modified: 2025/04/08 03:18
  • by kanget