This is an old revision of the document!


attended: Isaiah, Kayla

Updates

  • Slain the spaghetti monster
    • Replaced wires to make our board easier on the eyes
    • Doing so somehow fixed our problem. Sending and receiving now works without errors running on 3.3V
  • Able to send and receive packets from board to board
  • Added 3rd xbee, using one to send packet, one to route, and one to receive
    • Tried to add 4th xbee had problems sending and receiving packets

attended: Isaiah, Kayla

Updates

  • Updated gantt chart

Notes

  • Xbee computer to computer
    • Router to coordinator worked
    • coordinator to router did not work (coordinator sent packet to itself)
    • router to router did not work
  • Arduino to breadboard to computer
    • Arduino sends packet every 5 sec to breadboard
    • Breadboard receives packet, reads it, repackages, send to computer
    • Addresses of xbees are hard coded
    • Tested
      • Coordinator to router to router worked
      • Router to coordinator to router worked
      • Router to router to router worked
  • Setting PAN ID, make sure to refresh everything in the networking tab
  • Programming the arduino
    • make sure
  • weatherbox/bumblebee/week_10_-_march_21_2017.1490314489.txt.gz
  • Last modified: 2021/09/19 21:59
  • (external edit)