This is an old revision of the document!
Week 11
Meeting Minutes April 4, 2019
Attended: Mizpah, Sharmaine, Xiao
Updates
To Do
Meeting Minutes April 5, 2019
Attended: Mizpah, Sharmaine, Xiao
Updates
- Our PCB is neither sending or receiving packets so we tried changing the clock.
- Our sending works when we changed our clock from 16MHz to 8MHz
- when checking our bare board, with the voltage regulator our clock is getting 0.5V and output is 2.4V
- Alicia mentioned that usually, 16MHz clocks should run at 5V and 8MHz should run at 3.3V.
- Originally we wanted to keep our board at 8MHz since our board runs closer to 3.3V. However, we had trouble bootloading with 8MHz in the past.
- Due to that we resoldered 16MHz back to our PCB
- We'll fix our design again so our PCB would run at 5V
- So far, we know that the sending code works fine. The relay code may or may not be the problem. We'll further work with Firmware to figure out the relay code.