• Completed Two sets of range tests with the Xbee 3s and S2Cs
• Spoke with Dr. Kuh and discussed progress
• Created the new Bumblebee Inner and Outer housing → V3.0 housing and updated to V3.1
• 3D printed both iterations of Inner housing
• Updated Gantt Chart

• Setup New Xbee 3 pro as coordinator and router
• Try to collab with hardware team to do range testing with real data
• Continue to research and test housing + 3D printing → Will change roof design of Outer housing
• Current idea to use Waterproof tape for antenna hole and 'Straw star hole' design for bottom hole

Contributing authors:

Created by kanielap on 2025/02/27 02:44.