This is an old revision of the document!
Website Team Meeting - March 24, 2016
Attended: Keane, Dylan, Tyler and Garrett
Updates
- Final Draft of housing complete
- began printing bottom of housing
- Final touches completed on PCB
- PCB approved and ready to mill
Problems
- XBee able to communicate one way but not both (Resolved within the week)
- Ripped up breadboard to redo
- Problem fixed with help of Jaimie
- Xbee was not being powered
- Last minute changes to PCB
- Voltage divider connected to Atmega and Solar Panel diode to read panel voltage
- Add DCIN component to Schematic and then to PCB
- Last minute changes to housing
- make port for solar panel cable to charging chip
- account for battery
Reminders
- Figure out whats wrong with XBee (Resolved)