Attended: Keane, Dylan, Tyler and Garrett

• Final Draft of housing complete
  • Finished printing bottom of housing
  • Finished printing housing box
• Final touches completed on PCB
• PCB approved and ready to mill
  • changes to be made

• XBee able to communicate one way but not both (Resolved within the week)
  • Ripped up breadboard to redo
  • Problem fixed with help of Jaimie
  • Xbee was not being powered
• Last minute changes to PCB
  • Voltage divider connected to Atmega and Solar Panel diode to read panel voltage
  • Add DCIN component to Schematic and then to PCB
• Last minute changes to housing
  • make port for solar panel cable to charging chip
  • account for battery

• Figure out whats wrong with XBee (Resolved)

Contributing authors:

Created by tyamauchi on 2016/03/31 22:38.