296 Team Meeting (Unofficial) - February 2, 2017
Attended: Kyle, Akira
Updates:
* Finished tutorials
* Finished Bare Arduino
- Problems
- (1) Was unable to openthe serial port to program
- (2) Ableto open the port but FTDI programmer was not responding
- Solutions
- (1) Switched out faulty FTDI board
- (2) Realized that reset button has to be pressed after com port is opened
- Improvements
- (1) Got rid of the rest switch on the breadboard
- (2) Tied the FTDI rts port to 10 uF cap in series to the mcu reset pin
- Other notes
- Enable verbose on Arduino IDE while uploading
Discussions:
* Sensor Testing
* Eagle Schematic
* Xbee Testing (API Mode)
Reminders:
* Start sensor testing
* Make Linkedin Accounts
Authors
Contributing authors:
Created by kchan on 2017/02/08 00:48.