Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:bumblebee:week_3_-_september_18_2017 [2017/09/18 19:11] iaribal created |
weatherbox:bumblebee:week_3_-_september_18_2017 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| * Reset button | * Reset button | ||
| * Finalize design choices and start Schematic | * Finalize design choices and start Schematic | ||
| + | |||
| + | |||
| + | ==== Meeting Minutes September 20,2017 ==== | ||
| + | **Attended:Isaiah, Kayla, Rebecca** | ||
| + | |||
| + | * Tried to fix programmer not responding problem | ||
| + | * Swapped microcontroller, reburned bootloader | ||
| + | * Programmer would go through reading but stop when writing. Changed out RX and TX wires which fixed the problem | ||
| + | * After doing all that, it successful programmed without the use of the reset button. | ||
| + | * Trying a second time (without reset) didn't work. Worked when using the reset button | ||
| + | |||
| + | ==== Meeting Minutes September 22,2017 ==== | ||
| + | **Attended:Isaiah, Kayla, Rebecca** | ||
| + | |||
| + | * Worked on adding three additional debugging leds, believe issue to be resistor value | ||
| + | * Researched parts for schematic | ||