Attended: Kevin, Gordon, Tyler

• Board is dead Board was not dead, nor did water get inside
  • After getting back up on the roof, we discovered that the board transmitted after power cycling
  • We believe the board stopped transmitting due to a ghost voltage as it might have done before
• Revamped housing design
• Printed out Dragon Fruit Schematic

• Board died on Saturday February 11th
• Last packet sent was at 7:49 am
• There was a rainstorm on this day, water probably the cause
• No water damage, but uncertain why packets stopped sending
  • should try to make the housing more water tight
• Currently not deployed

• Program and debug populated board
  • Not having much luck
  • May need to do a board check
  • Possible that some parts need to be swapped out
• Battery Test (began on 4/17)
• Remove LED pins on MCP to use for Ghost Voltage Tests
• Decide where to place diodes, 0Ω resistors, and new parts
• Swap solar panel connector

Contributing authors:

Created by tyamauchi on 2017/02/14 08:48.