Dragonfruit Team Meeting - October 16th, 2017
Attended: Kevin, Kyaw, Tyler
Updates 10/16
- Started soldering circuit
Updates 10/19
- Continued soldering
- Found 0 ohm resistor (pkg 0805)
- Tested using heat lamp
- Voltage across VCC on the charging ckt (on board) spiked whenever we turned on the heat lamp to simulate the sun
- Spiked to ~6.4V and suddenly dropped back down to ~4 V
- This could be one of the problems why the board keeps dying
- Potential solutions:
- Capacitor (choose a right value?)
- If the voltage spike is due to current, we could use an Inductor
Tasks
- Review csv file for Weatherbox deployment analysis
- Code an arduino to monitor current drawn by charging chip
- Start soldering next week (Tyler)
- Start with charging chip
- Investigate short circuit current of solar panel (Kyaw)
Authors
Contributing authors:
Created by tyamauchi on 2017/10/16 21:21.