Attended: Keane, Kevin, Tyler, Kaeo

• Printed Housing over the weekend
  • Still need to print the solar panel parts
  • Need screws in order to launch
• Debugging Board
  • board does not program
  • tried to switch to a 8MHz clock in order to match the current firmware bootlegger, but it was unsuccessful
  • 8MHz clock also increased current draw from power source

September 29, 2016 update:

• Debugging Board
  • Hooked up Dragon Fruit Version 2 to a battery and solar panel to measure voltage readings.
  • Noise problem still occurred when connecting the battery and solar panel.
  • Initially thought noise problem came from XBEE, so we took the XBEE off of the board. But noise problem still persisted.
  • Noise problem might not be from XBEE, but sound increases when XBEE is plugged in. Could be due to additional resistances.

• Board cannot program
• Screeching still a problem

• Print rest of housing
• Meet with Firmware and get board programmed
• Work on solving screeching problem

• Remind Allie that Dragon fruit code should be similar to Cranberry
• Need to use a different bootloader for 16MHz

Contributing authors:

Created by tyamauchi on 2016/09/27 10:04.