We spent most of our hours today figuring out how to program ATMEGA 1284P. What we found is that we can do so by using FTDI, we would need to make sure that FTDI is the source that powers and grounds bare Guava. We were able to successfully program the blink test on it and confirm that the ATMEGA 1284P is boot-loaded with the boot-loader we burn in last week or so. But, what we found out is that the reset pinout is not assigned to the correct pin in ATMEGA 1284P, instead, it assigned to pin 1, which is the reset pinout for ATMEGA 328. Also, the pinout we have on the program does not match the output on ATMEGA 1284P. We think this means that the boot-loader we burnt is not correct, we would need to look for a different boot-loader.

Members: Diwen, Rylie, Max– Time: 3:30PM - 5:30PM