Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
weatherbox:guava:week_5_-_february_17_2020 [2020/04/10 01:04] dlin [February 19th, 2020] |
weatherbox:guava:week_5_-_february_17_2020 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| Today, we focused on connect the XBee to the standard layout and try to find out the error with the solar charging components. For XBee communication, the old TX0 and RX1 do not work anymore, we couldn't make it work, but we noticed that the REV C works, so we just going to end the bare Guava since everything else is working now and XBee problem will be fixed from the code we have right now. For the solar charging components, all we did was to check all the traces and do a voltage test to see if there's any current going through, which we found out it didn't, we were able to fix the basic schematic by following the schematic from the Adafruit's solar charging circuit. | Today, we focused on connect the XBee to the standard layout and try to find out the error with the solar charging components. For XBee communication, the old TX0 and RX1 do not work anymore, we couldn't make it work, but we noticed that the REV C works, so we just going to end the bare Guava since everything else is working now and XBee problem will be fixed from the code we have right now. For the solar charging components, all we did was to check all the traces and do a voltage test to see if there's any current going through, which we found out it didn't, we were able to fix the basic schematic by following the schematic from the Adafruit's solar charging circuit. | ||
| - | //Members: Diwen, Rylie, Max//-- | + | //Members: Diwen, Riley, Max// |
| //Time: 1:30PM - 4:30PM// | //Time: 1:30PM - 4:30PM// | ||