Verification Team Meeting - November 19, 2015
Attended: May Chen, Kristie Lee, Christie Obatake
Notes
- Apple sensor output pins (D - digital pin, A - analog pin)
- SDA/SCL: current sensor, pressure sensor
- JP3: pins 2 (A), 4 (A)
- Current Sensor (not measuring for current)
- Test power and GND
- Pressure Sensor:
- Figure out what to measure with SDA and SCL
- Anemometer sensor (Not on the sensor board, but can still test if it’s powered/grounded)
- JP3: pins 5 (D), 7 (D), 9 (D), 11 (A)
- Test power and GND through Arduino ATmega since it is found there
- Temperature sensor (two identical circuits for temp sensors)
- JP3: pins 10 (D), 12 (D)
- Figure out whether temperature or voltage is at Vout
- Humidity sensor
- JP3: 6 (D), 8 (D)
- Where on temperature sensor is this measured? Or which one?
- Power and GND
- P3: pins 1 (A), 3 (A)
- APOGEE solar irradiance
- has jumper pins (JP4)
- pin 1 = 5V, pin 3 = GND
- GPS
- pin 2 (VIN) = 5V, pin 3 = GND
Progress Check
- Working out the logistics of verification board so that we can select parts
Tasks
- Go over datasheets of Apple sensors and understand the pin outputs (see Notes for pin numbers)
- Select parts
- EAGLE layout
Completed
- Decided that we will be using Verification Board to test sensors on Sensor Board
- Examined Apple and Cranberry boards to see pin connections
Authors
Contributing authors:
Created by cobatake on 2015/12/02 02:47.