This is an old revision of the document!
=== Mesh Network Set up (Many-To-One) ===
- Configure all three remote devices
- add all three XBees (Collector, relay and router)
- update the firmware of each module
- Function Set: DigiMesh 2.4 TH PRO
- Firmware Version: Newest value
- Configuring the first device (Collector)
- First click the default parameter setting
- Then change these parameters
- ID: 7FFF
- NI: SENDER
- *IMPORTANT: there is already an empty space in NI, so be sure to delete that before naming module * Configuring the second device (can be the router or relay XBee) * Click the default parameter to reset parameters * Change parameters to: * ID: 7FF * NI: Relay_1 * API: Transparent Mode [0] ( or you cand do 1, we just left it at 0) * Write the radio settings * Configure the third device exactly the same as the second device. Setting NI as Relay_2 * Disconnect both the relay and router XBees and put them into their own power supply (we used two laptops) * Each module should be plugged into their own power supply by now * Radio modules should only contain the coordinator now * Using the laptop that has the coordinator, select the coordinator, and click the “discover the radio nodes in the same network * add all selected devices (relay and router Xbees) in the discovering remote devices === Testing the XBees Communications ===**
- Using the laptop containing the coordinator
- Using the laptop contained the router:
- Open up XCTU program and discover the router XBee
References: