This is an old revision of the document!
Week 1
Meeting Minutes September 6,2017
Attended:Isaiah, Kayla, Rebecca
- Board schematic
- Power for the board
- Solar charging chip and solar panel
- Debugging LEDs
- Uploading fix
- Bread board problems
- Xbee was no longer getting 3.3V
- Added a resistor to Vin of the xbee
- Now getting around 3.3V
Meeting Minutes September 8,2017
Attended:Isaiah, Kayla, Rebecca
Actions:
- Replaced both capacitors (both to 10 μF)
- Changed resistor added last meeting from 1 kΩ to 10 kΩ to receive steady voltage of 3.33 V.
Current Concerns:
- Found that 1 and 3 cannot communicate with each other
- Encountered two defective arduino boards
- Must add additional LEDs for debugging
- Find solution to rid of hardcoding address