• Solder, test, debug and deploy 2 Cranberry 4.0 board
• Continue debugging Cranberry 3.2 and 3.5 if there is time?

• Changed Cranberry hours
• Created a gantt chart

• Begin soldering (Joslyn: not MCU board Jen: MCU board)
• Review board design with Joslyn

• Tested all of the boards to see which ones programmed:
  • 3.5 white sensor: doesn't work
  • 3.5 white main: doesn't program at all
  • 3.5 red main: programs, doesn't sync
  • New 3.5 (BB): programs, syncs, doesn't run
  • Water damaged sensor: doesn't work
  • Water damaged main: programs, runs, doesn't get data
• Finished soldering new 3.5 sensor board

Contributing authors:

Created by jchun on 2017/09/06 21:37.