* Use the Arduino IDE to program the device using the AVRISP MkII Programmer.

• Use an ISP connector to attach the programmer to the Cranberry board.
  • Connections: MISO (1), VCC(2), SCK(3), MOSI(4), RESET(5), and GND(6).
• Make sure that you have the right board selected: Arduino Pro or Mini (3.3V 8MHz) w/ Atmega328.
• Note: Board must be powered using an external voltage source (e.g. battery or generator).

Burning the Bootloader

• Download https://github.com/nickgammon/arduino_sketches
  • Run board detector
  • Run board programmer
  • If it worked, you should be able to upload programs to it
• RESET (SS) - PIN 10
• MOSI - PIN 11
• MISO - PIN 12
• SCK - PIN 13
• VIN - 3V3

Authors