• Worked on the powerpoint for the CDR
  • Need to work on schematic to put into powerpoint
  • Problems slides - time and parts
  • Gantt chart - talk about how were gonna make up or change our goals
  • Progress - Schematic - Parts Order/Research - Documentation - Final Paper
• Worked on the test code for the BME280
  • Using the Arduino Uno and a breadboard to test the sensor until we can test it with our ATmega1284P
  • Using the I2C setup not the SPI yet
  • If we have time, we'll look into programming stardard pressure interface (SPI) (Serial Perpiheral Interface)

• Tested GPS with Ardunio -
  • Works with just the power(5V), ground, RX, TX pins
  • tried to compare the collected data to the datasheet values but hard to decipher
• Michael soldered new gps ultimate breakout
  • Messed up on the pins
  • But fixed it
  • Works

• Almost finished just need to add schematic/board layout stuff
• Polish it up
• Assign slides - maybe 4 per person? idk
  • Prolly whoever wrote the slide should talk about the slide like we did last time
  • 6 to 8 minutes means can talk slower / can talk less

• PDR → April 8th
• 496 Posters → April 27th

Back to Guava's Meeting Minutes

Contributing authors:

Created by dkvilla on 2017/04/04 04:05.