Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
weatherbox:guava:week_11_-_april_3_2017 [2017/04/04 04:05] dkvilla created |
weatherbox:guava:week_11_-_april_3_2017 [2021/09/19 21:59] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| * Problems slides - time and parts | * Problems slides - time and parts | ||
| * Gantt chart - talk about how were gonna make up or change our goals | * Gantt chart - talk about how were gonna make up or change our goals | ||
| - | * Progress - Schematic - Parts Order/Research - Documentation - Final Papes | + | * Progress - Schematic - Parts Order/Research - Documentation - Final Paper |
| + | * Worked on the test code for the BME280 | ||
| + | * Using the Arduino Uno and a breadboard to test the sensor until we can test it with our ATmega1284P | ||
| + | * Using the I2C setup not the SPI yet | ||
| + | * If we have time, we'll look into programming stardard pressure interface (SPI) (Serial Perpiheral Interface) | ||
| + | |||
| + | ==== GPS ==== | ||
| + | * Tested GPS with Ardunio - | ||
| + | * Works with just the power(5V), ground, RX, TX pins | ||
| + | * tried to compare the collected data to the datasheet values but hard to decipher | ||
| + | * Michael soldered new gps ultimate breakout | ||
| + | * Messed up on the pins | ||
| + | * But fixed it | ||
| + | * Works | ||
| + | |||
| + | ===== CDR Presentation ===== | ||
| + | * Almost finished just need to add schematic/board layout stuff | ||
| + | * Polish it up | ||
| + | * Assign slides - maybe 4 per person? idk | ||
| + | * Prolly whoever wrote the slide should talk about the slide like we did last time | ||
| + | * 6 to 8 minutes means can talk slower / can talk less | ||
| + | |||
| ===== Reminders ===== | ===== Reminders ===== | ||
| * PDR -> April 8th | * PDR -> April 8th | ||
| * 496 Posters -> April 27th | * 496 Posters -> April 27th | ||
| + | |||
| + | [[weatherbox:guava:meeting_minutes|Back to Guava's Meeting Minutes]]\\ | ||