We met with our group via Discord to update our Wiki meeting minutes. Worked on documentation while Oni and Dane worked on REV-D2.

Members: Blake, Max, Riley, Oni, and Dane Time: 1:30 PM - 3:30 PM

We decided to cut the bad trace and solder a wire connected to the pad in the back of the board to the correct pin on the atmega on our REV-DI board. We tried to get the board to send properly to the gateway but were unsuccessful. We tried re-bootloading the board and uploading the code, but it still only sent 1 heartbeat packet. So we are planning to go into the next lab and check to see if we soldered on the wire to the correct pin.

Members: Blake, Max, Riley, Oni, and Dane Time: 5:30 PM - 8:30 PM

Contributing authors:

Created by bwong on 2021/04/14 00:41.