Back to work on the bare arduino!

The issue from the previous week with getting the code onto the arduino has partially subsided. The tutorial that the group was following seemed to disappear! This led the group to following a new tutorial that was different from the previous which led to a few hiccups. This week we deployed an FTDI in an attempt to bridge the software upload issue, but there was limited success. The bare arduino blinked, but the wrong light was blinking. The board is a mess as it is just a collection of jumper wires which makes the problem of troubleshooting the issue that much harder. As of now we are focusing on cleaning up the board to be able to troubleshoot the issue and move on. The bare arduino has been the most significant road block in the groups progress and success thus far. However, it will make for a great learning experience.