Guava - Week of April 03, 2017
Updates
- Worked on the powerpoint for the CDR
- Need to work on schematic to put into powerpoint
- Problems slides - time and parts
- Gantt chart - talk about how were gonna make up or change our goals
- Progress - Schematic - Parts Order/Research - Documentation - Final Paper
- Worked on the test code for the BME280
- Using the Arduino Uno and a breadboard to test the sensor until we can test it with our ATmega1284P
- Using the I2C setup not the SPI yet
- If we have time, we'll look into programming stardard pressure interface (SPI) (Serial Perpiheral Interface)
GPS
- Tested GPS with Ardunio -
- Works with just the power(5V), ground, RX, TX pins
- tried to compare the collected data to the datasheet values but hard to decipher
- Michael soldered new gps ultimate breakout
- Messed up on the pins
- But fixed it
- Works
CDR Presentation
- Almost finished just need to add schematic/board layout stuff
- Polish it up
- Assign slides - maybe 4 per person? idk
- Prolly whoever wrote the slide should talk about the slide like we did last time
- 6 to 8 minutes means can talk slower / can talk less
Reminders
- PDR → April 8th
- 496 Posters → April 27th
Authors
Contributing authors:
Created by dkvilla on 2017/04/04 04:05.